Honda / Acura K20a K24a Engine Forum banner

1 - 20 of 27 Posts

·
Registered
Joined
·
929 Posts
Discussion Starter #1
I have many pics of everything step by step with additional pics of clearances etc...
 

·
Registered
Joined
·
929 Posts
Discussion Starter #3
I dont' have the header, axles, harness yet....


Ill get you the pics of the belt side. It is extremely close. You have to use spacers about half inch to the alternator to get belt tight.
 

·
Registered
Joined
·
929 Posts
Discussion Starter #5
I can help with the pics of the motor. Don't have axles yet.

Im also getting my pictures from my friends computer of the clearance of the belt asap.
 

·
Premium Member
Joined
·
456 Posts
drhonda said:
How about the belt side of the motor, the clearance for the belt and the side of the car? Also, how about a pic of the headers/exhuast? Thanks, thsi will help a lot.
If you searched you would see a picture of headers on hondata's race car.

Or LHD drive integra race car.

Theres is no problem with oil pan clearence, you wont be seeing axle angles like an h22.
 

·
Registered
Joined
·
929 Posts
Discussion Starter #7
I have lots of pics of the motor hang in my car. Ill post tonight.
 

·
Registered
Joined
·
929 Posts
Discussion Starter #8




Height of car is measuring in front from floor to fender crest is 23 1/2 inches in front and rear is 25 inches
 

·
Registered
Joined
·
929 Posts
Discussion Starter #10
No problem you can always raise your car up to where you feel comfortable if you have coilovers.
 

·
Premium Member
Joined
·
7,171 Posts
Does anyone make any aftermarket oil pans for the K-series yet? maybe something that won't hang quite as low?
 

·
Registered
Joined
·
929 Posts
Discussion Starter #12
I can't remember where but I know a company is working on it.
 

·
Premium Member
Joined
·
7,171 Posts
C-Zero said:
That height is normal.
As normal as a K series in an EG can get :!:
 

·
Premium Member
Joined
·
456 Posts
jon v said:
C-Zero said:
That height is normal.
As normal as a K series in an EG can get :!:
Normal for K20egs, or HR mounts.

They both are dimensionally the same but you can't say that for Hasport.

You will just have to wait and see about theres.
 

·
Registered
Joined
·
929 Posts
Discussion Starter #17
Special Request by DR HONDA



 

·
Registered
Joined
·
4 Posts
C-Zero said:
That height is normal.
Yeah it may seem perfectly normal but its also perfectly dangerous. This engine costs a loooot of money to slap in a car that has an engine bay not tall enough to compensate for that oil pan.
 

·
Registered
Joined
·
929 Posts
Discussion Starter #19
understand that...

Im going to raise my car about a 1 1/2 inches.
 

·
Premium Member
Joined
·
456 Posts
137 said:
C-Zero said:
That height is normal.
Yeah it may seem perfectly normal but its also perfectly dangerous. This engine costs a loooot of money to slap in a car that has an engine bay not tall enough to compensate for that oil pan.
Did you read my last post?
 
1 - 20 of 27 Posts
Top