Honda / Acura K20a K24a Engine Forum banner

How to: type s water pump and oil cooler with k24

135K views 117 replies 49 participants last post by  Jaimepagantattoo 
#1 ·
What you need:

a2/z1 water pump
a2/z1 oil cooler
associated hoses

joint cooler from s2000
part # 11107-pt2-000 ~$5.00

1. Remove plug.


CIMG0639 by cjk_142001, on Flickr

Install s2000 joint cooler as seen below.

2. install a2 or z1 oil cooler and filter.


CIMG0661 by cjk_142001, on Flickr


3. install a2 or z1 water pump


CIMG0660 by cjk_142001, on Flickr


4. Install misc hoses



5. Karcepts ac/ps removal pulley kit :up:


CIMG0659 by cjk_142001, on Flickr


ENJOY!
 
See less See more
4
#30 ·
The water pumps are significantly different and require the proper coolant passageway be used.

A2 on the left
 
#33 ·
longer oil life,more stable oil temps reducing the effects of having oil too thin(bearing and piston wear)

it's beneficial enough honda installed them on a few of their newer cars....
 
#34 ·
need help asap, do u still need to take out the threaded part that the filter screws on to on the k24block to bolt on the oil cooler assy or you can just slide the oil cooler on?
 
#39 ·
thats what i was thinking but i was scared about it not coming off and just totally destroying the filter thread, so instead of just installing the oil cooler on the block i just ran a hose from the a2 pump strait to the block bypassing the oil cooler. anyone know if this would cause problems?
 
#54 ·
The pump with the actual housing? No. There's a part where the bolt holes won't line up near the back since it's got an extension.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top