Honda / Acura K20a K24a Engine Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
1,614 Posts
lol, this is just to say you have five lug with out spending five lug money. its not done all the time because doing it this way only lets you use the 5x1.14 wheels. but doing it this way doesnt give you typeR stopping abilitty. if you want some thing like this done its easy press out your hubs, have them redrilled in a 5x1.14 patter as well as your rotor to match and your done. five lug wheels with out five lug money or stopping power.
Sup Carlos this is Joe with the em1,hows the hatch???
 

· Registered
Joined
·
1,614 Posts
The fronts are actually rather easy, the front hub assembly from the 97-01CRV is the exact same thing as the USDM Type R, so go to your junk yard and get those and your half way there, the tricky part will be the rears, there is a DIY on Honda-tech that tells you how to use your 4 lug rear arms with the 5 lug hubs, bearings, and a mazda something nut to hold it all together, also the RSX type s rear calipers are the same as Type R as well so you can put it all together for alot less than the conversion you just need to research and be patient.
The Usdm Itrs hubs are 32mm and the Crvs Hub are 36mm.Also the thread is here that I posted before.:)

http://honda-tech.com/showthread.php?t=1978033
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top