Honda / Acura K20a K24a Engine Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
285 Posts
Discussion Starter · #1 ·
In the past ive seen some guys with B-series motors running around 12.7:1 CR on pump gas(and Hondata/Uberdata of course). With all the advancements in the K20A, how high do you think it can go on pump gas?
 

·
Registered
Joined
·
45 Posts
I truly can't answer that question till i put them in and check mechanically. I would say yes do to the valve pocket being cut as deep as the stock one, but I still would like to check.
 

·
Registered
Joined
·
15 Posts
mahle rocks, ive used them in 2 other motors(not k series) they are very nice.....they made the first alum. pistons ever!! cool shit. then again there are alot of good piston companies out there but everyone will always argue who is the best.....
 

·
Registered
Joined
·
2 Posts
I'm getting parts one at the time..NO motor yet already have the same exact piston as the previous post.I also have ef ready to have K swap.But no money for now :(
 
1 - 12 of 12 Posts
Top