Honda / Acura K20a K24a Engine Forum banner
1 - 4 of 4 Posts

· Registered
270 Posts
Discussion Starter · #5 ·
Sorry to sound so dumb about something like this, but i was just wondering where the plugs went that didnt come labeled connect to.

Where do the bigger connector and the smaller one thats loomed with the 5 hanging wires connect to?

And these are the extra 5 wires i have to wire in right? Where exactly to the dash harness do i wire those is?

Here's the 3 connnectors i have no idea where they connect to.

And heres a pic of the ground, and the connections for the fan switch and temp. sensor.

Which brings me to my next question, Katman, How did you run your temp sensor and fanswitch with this And which ones are to be used? Ones from my old D motor?

Also do you have pics of how you neated up the job to make it look nice with zipties and wire loom you were talking about? Im more of a visual learner, and when this harness didnt come with instructions it left me confused. LOL
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.