Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

·
Resident Journalist
Joined
·
501 Posts
Discussion Starter · #1 ·
sup guys, i am picking up a set of k20 twm individual throttle bodies. do you guys know if i can still use my stock throttle cable? and also what size fuel injectors are you guys running with the ITB's with just stock components on your engines? also what about the vacum part of the throttle bodies? how di dyou guys set that up, and what is that one sensor called that reads the vacum..... all help would be greatly appreciated
 

·
Registered
Joined
·
565 Posts
What sized ITB's I run a huge injector like 625cc since it all we had avaiable here at the time I installed the ITB's on my car.. I was going to use a 450cc or 500cc but they were out of stock.. Provided you have a good computer you can adjust the fuel pressure and the injector flow to suit.. I think my injectors run at about 60% or something like that..
I run the stock throttle cable..
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top