Honda / Acura K20a K24a Engine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I am currently rebuilding a k20 that I have purchased and when I was prepping to install the crank I noticed the damage on the lower part of the sleeve which seems to be a smack of a broken conrod. I am planning on keeping the motor stock power.

Will it be a problem / will it develop into a bigger problem if I continue building the motor? 😅

Thank you in advance!
 

Attachments

·
Registered
Joined
·
279 Posts
looking at the bores general state, I suggest you clean and chamfer this edge and ideally have the block bored to the next suitable size.
if you already have pistons, at least have it honed.
 
1 - 2 of 2 Posts
Top