Honda / Acura K20a K24a Engine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
153 Posts
Discussion Starter · #1 ·
Hey,

I started a tube frame a while ago and it is time to install the engine and make engine mounts.
Now i doubt from where i have to measure in order to obtain equal drive shafts.
Engine is a k24a3 with a k20 gearbox.
Do i have to measure up to the seals of the gearbox and the intermediate shaft?

greetings
 

·
Registered
Joined
·
2,807 Posts
That's up to whoever's making the axles for you. When mine were made I was told to measure "flange to flange."
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top