Honda / Acura K20a K24a Engine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter #1
Anybody use the EM2 Clutch Master Cylinder in an Integra?

I bought one the other day from Honda and installed it and the clutch pedal sat like 1/2 inch from the floor??? The cmc rod seems like it's way too short, even after i adjusted the rod to like few threads were left, it still was like 1 inch from floor, couldn't lift the pedal up or anything.

I thought people were using these as direct bolt on?
 

·
Premium Member
Joined
·
10,289 Posts
You probably need to swap the push rods. I couldn't tell you though for certain without a side by side picture
 
1 - 2 of 2 Posts
Top