Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

·
Banned
Joined
·
15,815 Posts
Discussion Starter · #1 · (Edited)
This is a custom header made by DANNY TRAN RACE FABRICATION

or for short DTR Fab www.dtr-fab.com











Got this off clubrsx http://www.rcrewracing.com did the dyno I believe..

214.7 whp 149 lbs of tourqe on Dynojet
Stock K20a DC5R
Stock DC5 PRC ECU
Stock rigged intake
Chevron Techron 91 pump gas
55 lbs of fuel pressure
Full exhuast with 2.5" piping (Buddyclub spec 3 for JDM EK9)

For my next session they will use a Mugen N1 ECU and also Hondata K PRO.


 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top