Honda / Acura K20a K24a Engine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1 (Edited)
Disregard. It's apparently the bolt.

I'm installing a set of DC cams and have encountered a problem. The 8mm pulse plate bolt on the exhaust cam will not screw in smoothly. I'm afraid to put any real pressure on it, but it goes in a few turns by hand and starts to get tight. Anyone experience something like this?

Thanks
 

Attachments

·
Registered
Joined
·
42 Posts
Running the same set up in my k24a3 motor

Mine when in fine coz I used my current bolt from old cams and when fine,

Wanting to know what pistons u running at the moment with that set up?

Sent from my EML-L29 using Tapatalk
 
1 - 3 of 3 Posts
Top