Honda / Acura K20a K24a Engine Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter #1
hey all,

thought i'd share my build.

to date, have owned my car for 2 years and 11 months. got it stock and has been through quite a few sets of wheels and slowly getting modded to enhance its performance at the track.

I'll list my mods, and my future plans etc;

Engine:
- Injen CAI
- TODA Header W/ 200cell Hi-Flo Cat
- Spoon N1 catback
- Hondata KPRO tuned to 140atw by BYP Racing & Developments

Suspension:
- Buddyclub RSD
- Hardrace Rear Camber Kit
- Ingalls Camber Bolts (2sets)
- PCI Offset Bushings
- Hardrace Roll Centre Adjusters
- Todds Modified OEM Tie Rods

Brakes:
- DBA 4000 Slotted and Wiped Rotors (F)
- Ferodo DS2500 Pads (F)
- OEM Blank Rotors (R)
- ADB Racing Pads (R)
- Goodridge Braided Brake Lines
- Motul RBF600 Brake Fluid

Wheels & Tyres:
- Desmond Regamaster EVO 17x9+18
- Dunlop Direzza Z1 Star Specs 235/45/17


Plans are to go back down to a 235/40/17 tire size and reduce the rear camber 0.25 - 0.50 of a degree

At the moment I am planning to upgrade my drivetrain with some nice mods;

have picked up;

Wavetrac LSD
lightened flywheel

still to get;

5.062 FD2 FD
tsx 6th gear
exedy stage 2 clutch kit
civic si CMC

 

·
Registered
Joined
·
77 Posts
Discussion Starter #6
Finally got my new wheels.

17x9+18 regamaster evo in white. brand new, never used. the advertisement said that these wheels were testfitted on a FD3S and the 17inch wheel would clear the 350mm rotor. I guess the largest sized rotors I'll ever get will be 330mm then haha!

Unfortunately I only received 3 of my 4 wheels :(









Quite some dust on them with the trip from Japan to Australia.

The valve stem has a bit of rubber that looks old and brittle. Will get some RAYS black valve stems and give them a go.

Hopefully on Monday or Tuesday I receive the regas, and on Wednesday I can go get them fitted, alignment too!
 

·
Registered
Joined
·
77 Posts
Discussion Starter #7
I have always been a fan of white wheels and IMO they look classy and sporty on the Magnesium Mettalic paint.

First set of wheels;

EP3R wheels in white 17x7+20 (25mm spacers)



Enkei NT03 in white;



This shot is my favorite as it shows the colour combination. I really like the MM shell, Red interior, now down to the choice in wheel colour. I really like the Gold wheels on the MM, as well as the White wheels on MM. However with the red interior, I felt the red and gold would clash too much... White it had to be.

I thought after putting the wheels on, I'd go back to the same spot and take the exact same photo as the phot above with the NT03's;



Their so fucking bright and white lol! *needs sunglasses*
 
1 - 12 of 12 Posts
Top