Honda / Acura K20a K24a Engine Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
175 Posts
Discussion Starter · #1 ·
Have a 91 CRX SI swapped with a K20A (type-r). I have ground control coilovers and adjustable shocks up front. I have an ST sway bar up front, poly bushings in the control arms and a traction bar. At cruising speeds, hitting bumps causes my car to steer itself slightly. Its not bad, I just keep one hand on the wheel at all times. But is ride quality this bad with all these parts installed? It handles nice and all, but for cruising, it kinda sux. Any input from anyone?
 

· Registered
Joined
·
175 Posts
Discussion Starter · #2 ·
got it figured out.....if you have traction bars installed, please, and I do mean please, get an alignment, and pay special attention to the caster. I though I had my wheel placed pretty much dead center in the wheel well, but it was 6 degrees off, which may not seem like much, but enough to cause problems.....
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top