Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

·
Banned
Joined
·
320 Posts
Leaving aside the issue of the losses in the low end - it seems that the only real gains are above 8k, and there is actually a loss from 7k-8k. It seems like this motor may be a little over-cammed? We know the K head can flow enough to support that power to 9.5k as shown here, but maybe this motor just won't make enough velocity to fill the chamber with this setup?

I'd like to see a dyno of these cams in a k20a... I wonder if the higher compression would make that motor a better match with the Crower 3s...
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top