Honda / Acura K20a K24a Engine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3,948 Posts
Discussion Starter · #1 ·
Hey guys,
I am swapping a k20a2 into my eg. I can get a really good deal on a comptech rsx race header. I know its not supposed to fit, but is there any modifications that can be done to make it work? Does it hit the rear crossmember or the steering rack or what? Thanks in advance
 

·
F1 Junky
Joined
·
2,017 Posts
You'll have to use the Comptech TSX header, that what I'm I'm using on my EG.
 

·
Premium Member
Joined
·
7,171 Posts
real good deal?

like the man said, buy it and make some money off of it...
 

·
Registered
Joined
·
3,948 Posts
Discussion Starter · #5 ·
Soda Popinski said:
I believe it hits the Cross member. If i were you, i'd flip it and make some money and go with a DTR fab header, or A RMF one.
Do you think it will hit the crossmember near the mount? If not, i could notch the crossmember out to fit it
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top