Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I'm thinking of completely rewiring my dc2 with a kmotor installed and only leaving wiring that i really need. Everything vital would just be turned on/off via switch panel and kill switch. This is not a daily driven car, but might be driven on the street occasionally so i will still use headlights and such.
My question is...As far as the project goes is there anything that i should need to watch out for. My plan so far is to wire switches for Ignition,fuel pump, ECU/dash guages, starter, kill switch will handle main power and alternator, headlights, wire the corner lights and turn signals somehow,windshield wipers(on/off).

No a/c, ps, abs, interior lighting, basically just the essentials for the car to run. Any help or expertise in this area would be much appreciated
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top