Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

·
Banned
Joined
·
15,811 Posts
Discussion Starter · #1 ·
ok i am going to do a complete k20 type R swap into my 94 cx hatchback and i was just wondering if i needed anything else like besides all the obvious shit, but i heard i needed a new fuel rail and i know that i need a new header cuz the stock one hits the firewall from what i heard but can anyone tell me the things i need? besides the obvious, Motor,tranny,ecu ETC....
 

·
Banned
Joined
·
15,811 Posts
Discussion Starter · #2 ·
My list of extras
Mounts, axles, clutch line, fuel line, FPR, heater hoses, radiator hoses, new clutch w/resurfaced flywheel, lots of loom, wire ties, kpro, primary air fuel ratio sensor O2, shift cables, shift box, 3M black tape, wires to extend some wires for harness power wires etc., B series engine coolant temp sensor, pins for cluster, all fluids, vaccuum hoses, prototype racing intake, extra tube needed to be welded to intake, brake booster hose, thin fan, 6spd gear shift knob, load leveler for putting motor in, new exhaust, header, make sure all sensors are good, fuel rail STR, STR alternator pulley, STR TB coming. have to relocate radiator to condensor position. Air temp sensor from stock rsx or SI air box.
This is all I can think of right off the top of my head.

I also have a guide using powerpoint on cd of the steps to take with lots of pics and tutorial if interested.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top