Honda / Acura K20a K24a Engine Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
23 Posts
Discussion Starter · #11 ·
Ok, skip the drama of peoples buisness lives and lets get back on topic guys. Tell me what I'm missing

1. Debur and smooth out the head and make it so no gasses and what not can be trapped in.

2. Thin head gasket.

3. See if Endyn could possibly make a rollerwave piston if they're sent the correct specs.

4. Proper tuning..which is an obvious given.

Now as for the combustion chambers...how must they be worked..and did I forget anything else that should be done?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top