Honda / Acura K20a K24a Engine Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
739 Posts
Discussion Starter · #1 ·
Anyone elses Hybrid racing clutch line not bolt right in?? I have to have some type of fitting for it to go into the pressure switch or whatever the little silver thing on the firewall is. I dont remember but I may have to have a another fitting to go into the slave cyl. as well. Anyone else have this problem? I was hoping to buy it and it go right in
 

·
Resident Journalist
Joined
·
501 Posts
you are most likely not putting it in straight when you are screwing it into the "clutch master cyclinder"..... just be careful not to strip it, im pretty damn sure that the guys over at Hybrid have all ready made sure that it would be an exact fit before they would even start selling it...
 

·
Registered
Joined
·
739 Posts
Discussion Starter · #6 ·
gald you people know, the hybrid instructions arnt very indepth. It dosent say anything about those 3 wires I posted about (red,white,blue ones) and a few other things. But I guess thats what I have you guys for and I can call hybrid but I prefer not to bother them.
 

·
Registered
Joined
·
109 Posts
i see you guys got it figured out....but just for referrence...i used a brake line from pepboys that they stock...dont remember the part #, but it was a european hard line bout 4 ft. long that i bent myself to make it run along the frame rail and in front of the radiator to the slave....had the correct size and pitch fittings on both ends....hope that helps any one else that didnt buy it from hybrid or any other part maker...if i could figure out how to post pics i will....
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top