I have a built Kseries motor, Blueprinted by IPS and built by CLUTCHMASTERS RACING
Motor specs
Fully built bottom k24
K24 ERL Superdeck 2 block (88mm)
IPS signature series 9:1 pistons
Cunningham Rods (IPS spec)
Castillo custom crankshaft (99mm)
Calico Coated ACL Bearings
AEBS Headstuds
Type S Head
Type S Tranny
Wiring Harness
Bottom end has zero miles on it
head and tranny have less than 20k
spent well over 7k in this
4500 obo
Motor specs
Fully built bottom k24
K24 ERL Superdeck 2 block (88mm)
IPS signature series 9:1 pistons
Cunningham Rods (IPS spec)
Castillo custom crankshaft (99mm)
Calico Coated ACL Bearings
AEBS Headstuds
Type S Head
Type S Tranny
Wiring Harness
Bottom end has zero miles on it
head and tranny have less than 20k
spent well over 7k in this
4500 obo