Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

· Registered
1,187 Posts
Discussion Starter · #1 ·
i have a set of blueprint rods and CP piston for my K24 build. i was gonna hang the pistons myself before bringing them to the machine shop. and the wrist pins for the pistons dont fit through the bronze bushing of the rod. im wondering if they have to be honed to fit cause they are supposed to float free? im assuming yes but would like to get an answer from someone who knows for sure. thanks guys.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.