Honda / Acura K20a K24a Engine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
655 Posts
Discussion Starter #1
does anyone know what belt to run with a k24 with type s head ep3 idler pulley and type s ac compressor???

52 without the compressor right??

thanks
 

·
Registered
Joined
·
457 Posts
take a long piece of string... route it like you would route the belt... take it off... measure it... and go to your local parts store and have them match it up. just make sure they get you a 7 ribbed belt.
 

·
Registered
Joined
·
457 Posts
to be honest im not too sure. 6 out of 7 ribs, i dont see any problem. i guess the only thing is off setting the pressure put on the bearing but i don't think it will affect much, if not any. can anyone else chime in on this?
 
1 - 5 of 5 Posts
Top