Honda / Acura K20a K24a Engine Forum banner

axle help

3067 Views 19 Replies 7 Participants Last post by  r_fkn_1
2
wassup k20a.
in need in some help again. i have an k20a2 ek civic w/32mm 5 lug. im trying to change my passenger side axle but i cant to seem to remove the inbound joint that connect to the drive shaft or 1/2 shaft. im hammering away a it but its not budging so i just want to buy a new one.
so, may someone please tell me what this part is called, that is connected to the trans. the shaft in the middle of the cv axle and trans.
thanks.

***edit***new***
i bought 2 passenger side axles (1 type-s, 1 gsr). i removed the inbound of both axles, then placed the type-s inbound onto the GSR axle. did i do that right?



See less See more
1 - 2 of 20 Posts
^yes you want to swap outside part as your car has smaller spline/hub

on side note i have been beating on base rsx axles from autozone for awhile with no issues, no swapping anything what so ever. go to autozone pay $120 for two axles, slap them in, beat on them till they break and exchange with lifetime warranty when they do. quite few others on here run same GSP advance/ autozone axles also. just dont tell autozone its a swapped car it will void warranty, just say you have a base rsx.
pm returned. just get a set of base model rsx axles and slap them in.
1 - 2 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top