Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
501 Posts
there are a couple xtra steps included in the instruction manual for karcepts shifter box that you need to do for an originally auto chassis. i installed the shifter box in my ek chassis, it is very easily explained in his instructions.

as for wiring ...k-dub on here was explaining it to me last night. on the auto shifter assembly saftey switch there are 2 thick wires which need to be cust and wired together. then there are about 8 misc smaller wires on the switch. 2 of them are for the reverse lights. k-dub couldnt remeber which 2 it was and my camera sux so all i could give him for close up shots of it were blurry pics. if anyone can take a close up clear pic of the safety switch..he will be able to point out the 2 wires that you wire to the reverse sensor on the tranny.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top