Honda / Acura K20a K24a Engine Forum banner
1 - 9 of 9 Posts

· Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
I recently just picked these mounts up for 300 bux and was wondering if these are okay mounts or the ones that make the oil pan hang to low? I was told they are hybrid racing mounts but they look different then the billet ones they sell? Are they an older version of them? Let me know Id appreciate info on them.

 

· Registered
Joined
·
81 Posts
Discussion Starter · #4 ·
I bought them because they were the only 300 dollar set of k20 engine mounts that exsist lol. And if they were bad I could sell and get money back out of them. But good to know thanks.
 

· Banned
Joined
·
320 Posts
yes you will be fine with those mounts, the only issue will be poor oil pan clearance (approx .5-.75" lower than HAsport by my estimate). A good friend of mine has been running his car for 6 months with the original K20EG mounts which are identical to those and he hasn't had any problems (other than two cracked oil pans lol). His car makes 300+ whp and he has launched it on slicks so I don't think they're gonna break or anything...
 

· Registered
Joined
·
1,990 Posts
lol... K20EG, whatever happend to that guy?

is he still making mounts, and still getting his fuel rails made by STR or did they ditch him? that whole incident was alot of bad publicity, it made me steer away from buying stuff off him
 

· Punishin' Bitches
Joined
·
2,446 Posts
909edge said:
yes you will be fine with those mounts, the only issue will be poor oil pan clearance (approx .5-.75" lower than HAsport by my estimate). A good friend of mine has been running his car for 6 months with the original K20EG mounts which are identical to those and he hasn't had any problems (other than two cracked oil pans lol). His car makes 300+ whp and he has launched it on slicks so I don't think they're gonna break or anything...
ROFL :confused:
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top