Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

·
Resident Journalist
Joined
·
501 Posts
Discussion Starter · #1 ·
well, from talking to some of the people that are building the k motors, a lot initially had problems with spinning rod bearings. As of right now, my k24 block is about to get sleeved, and im about to pick up the crower rods. Is there anythign i can do to the bearings to prevent this from happening after i sepnt gobs of money on it.. I think any information given here will definitely help out all the guys that are building up their motors here on this website. Hopefully we can get some info from Nikos and the Marouj ....
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top