basically, they are made to work with stock pistons.. aftermarket pistons are 22mm I believe.. stock is 21mm.. not sure, have to look up the numbers
after market piston/rod Wrist pin problem..
I went to assemble my engine today all brand new parts eagle rods for the K24 part# crs5984k3d and CP pistons pt#sc70451
The wristpin bore is too small, by alot... from my understanding eagle rods are new to the k24 was there a bad batch out there i should know about?
has anyone had this type of problem with either brand?
im going to give them a call tomorrow.
The wristpin bore is too small, by alot... from my understanding eagle rods are new to the k24 was there a bad batch out there i should know about?
has anyone had this type of problem with either brand?
im going to give them a call tomorrow.
1 - 1 of 14 Posts
1 - 1 of 14 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda / Acura K20a K24a Engine Forum
A forum community dedicated to Honda and Acura K Series engine platform owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, power-adders, racing, maintenance, and more!
Full Forum Listing
Recommended Communities
