Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
167 Posts
c_buz said:
stock motor??? I thought stock sleeves can only handle 11 psi at most? And what about running 18psi on 11:1 CR?? Uhmmm I think they aren't telling the whole story. And even if it was stock, how long would that motor really last anyway. I think what they really meant is : "stock" motor. hehehehe

P.S. Impressive numbers though. :up:
What! That sounds like something you would hear form The Old One ( Endyn). That much hp would push the rods right off the crank.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top