Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #5 ·
c_buz said:
stock motor??? I thought stock sleeves can only handle 11 psi at most? And what about running 18psi on 11:1 CR?? Uhmmm I think they aren't telling the whole story. And even if it was stock, how long would that motor really last anyway. I think what they really meant is : "stock" motor. hehehehe

P.S. Impressive numbers though. :up:
Its all in the tuning. There is no set limit of what the stock sleeves, pistons, or rods can handle (atleast not yet).
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top