Honda / Acura K20a K24a Engine Forum banner
1 - 20 of 184 Posts

· Registered
too many to list, Currently a 2007 Acura RL w/ CMBS
Joined
·
2,418 Posts
Discussion Starter · #1 · (Edited)
Here's my slow work in progress...

the shell is a 1994 LS that i got from Blake aka Notorious92rhdEG... the car started out as a bare shell that is super clean, i always wanted a rhd teg so i fig nows the time, heres a list of the plans... then pics

Exterior
-Champ White
-JDM ITR Front
-Seibon Carbon Hood
-Carbon hatch (Painted Champ White)
-ITR Rear Spoiler
-Amber Side Markers
-16" TE37's
Interior
-Red Recaros
-Rear Stripped
-ITR Carbon Console, Climate, & Cluster
Engine
-300+ whp All Motor
-K24A2 w/ P&P Head, Lightened Crank, H Beam Rods, 12.5:1 CR, Supertech Valve Train, Unknown Cams
-Type S Trans (geared with ep 1st & 2nd, type s 3rd-5th, tsx 6th & fd)
-PRB Kro
-ITB's
-K-Tuned Race Header





Drilling out spot welds


Got the windshield out


Got my RHD clip











STAY TUNED . . .
 

· Registered
too many to list, Currently a 2007 Acura RL w/ CMBS
Joined
·
2,418 Posts
Discussion Starter · #14 ·
breaking down the engine to make sure everything is straigh, was told the timing chain jumped a couple teeth



lil bit of carbon build up but the cylinder walls are clean and all the valves look straig



gonna break down the head later today/tomorrow and start the cleaning process this weekend, gonna port and pollish so stay tuned...

more pics to come
 
1 - 20 of 184 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top