Honda / Acura K20a K24a Engine Forum banner
Cancel

Search Results for ‘vtec engagement’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results

Search Tags

accord acura all motor boost cams camshaft cheap civic civic si clutch crv crx ctr dc2 dc5 drag racing ecu ek9 em2 engine englishtown ep3 exhaust for sale gsr harness hasport hatch head header honda honda day hondaday.com hondata hybrid racing injectors intake manifold integra ips ips k2's itr jdm junk2 k series k swap k-series k-tuned k20 k20a k20a2 k20a3 k20z1 k20z3 k24 k24 block k24 build k24/k20 k24a k24a1 k24a2 k24a4 kpro kseries kswap ktuned lsd manifold mounts mugen nyce1s nyce1s.com oem oil pan parts pistons prb rbc rods rsx rsx type s s2000 shifter skunk2 skunk2 cams supercharger suspension swap throttle body tranny transmission tsx tuning turbo turbo civic type r type s vtec wheels wiring wtb
  1. General K-series related talk
    Recently swapped to a RBC gear on my ‘06 TSX (K24A2) while I replaced my timing chain. Since then, I have a P0341 code and the most common fix is replacing the timing chain, but others have reported that replacing the VCT solenoid solved it. Mine sat outside the vehicle overnight and I’m...
    check engine vct vtec engagement
  2. General K-series related talk
    Help, I have a 1997 civic k24a2 swapped and when I go into vtec in any gear at 4,000 rpm’s it makes this rattle/tapping noise, and it’s only at 4,000 rpm it does it. It sounds like it’s in the head?, I replaced the vtec solenoid thinking it might be that but it wasn’t, it only does it under load...
    help k24a2 rattle tapping vtec engagement
  3. Honda Fit / Prelude / Accord K-series Swap
    I'm having an issue where VTEC on my K24A is not engaging at all. I swapped this engine into a 2003 Honda Accord EX. This is indeed the 3-lobe VTEC engine. I am using a factory ECU with KTuner. VTEC engagement is set at 4800 RPMs. I have sufficient oil in the engine as I've triple checked this...
    k24a k20a2 vtec vtec engagement vtec pins
  4. Engine Building
    Hi guys I have a recently built k20a2, since the rebuild the car lacks power, it crosses over into vtec, but I feel no power gain and its asif the car hits a wall once it reaches 7k rpm. You also get a strange (backfire?) Noise from the engine bay when it reaches 7k. The crossover is audible...
    k20 rev limit vtec vtec engagement
  5. General K-series related talk
    Hi all, first post not sure if this is the correct area. So I have recently rebuilt my k20. After the build I had a code for an 02 sensor, replaced sensor, all ok code went away. First test run of the car shown that it wont engage vtec, it gets past the vtec engagement rpm and just revs out...
    ep3 idle vtec engagement
  6. All Motor K series Technical Discussion
    Whats up K20 Fam! i recently took my car to get dyno (em2 k20a2 kpro) and the tech came out and said vtec was not engaging so they check oil pressure & vtec signal and all as good. so they decided to pull cams to check pins to make sure the bc cams where installed right...everything so far...
    k swap lack of power vtec engagement
1-6 of 6 Results
Top