Honda / Acura K20a K24a Engine Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. General K-series related talk
    Anyone know the difference between the k20z3 oil chain tensioner vs the k24a's? Here's some part numbers for reference: K20Z3 - 13450-RBC-004 K24Ax - 13450-RAA-A02 I realize they're different part numbers, I'm pretty much asking because of the price difference and if there's a...
  2. All Motor K series Technical Discussion
    so some of you may remember my thread last week about not being able to get the motor to time, well finally we got it timed but now on to my next problem :facepalm: from what it sounds like my go power dual valve springs are binding on each other.. like the two springs rub on each other as i...
  3. General K-series related talk check the video out!
  4. All Motor K series Technical Discussion
    A while back I heard a ticking noise I thought was the timing chain. Turned out it was just the header heat shield, but I decided to upgrade to the Skunk2 timing chain tensioner as a precautionary measure. I had heard good things about it. Honda Tuning sang its praises. and CRSX had...
  5. All Motor K series Technical Discussion
    Got this today on a customers car, anyone seen something similar? K20A2 Toda N2 Cams with N2 Valvetrain
  6. 1992+ Civic EG / DC2 / EK K-Series Swap
    posted elsewhere, but no attention was give, here goes again then >>:) are the bolt patterns on the K24A2 and K20A's water passages the same? i.e. can i use a EP3 idler pulley on my K24A2 motor, will it bolt right up? if not, are the water passages on the 2 blocks (20 & 24) the same...
  7. All Motor K series Technical Discussion
    But who has the solution? Chunky does. :p Watch the video, and please read this entire thread. I have a very good idea of what is causing timing chain failures with skunk2 cams now. Let's see if someone can guess what the problem is. Some notes...
1-7 of 7 Results