Honda / Acura K20a K24a Engine Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. Engine Building
    I'm currently building a k24/20 motor with forged internals. I measured my main bearings just fine with a dial bore gauge, but I bought a 2-6" one, without thinking about how the rod journals are smaller. Dial bore gauges that go down below 2" all seem to be $150 and higher, so I decided to try...
  2. General K-series related talk
    Hello there guys and girls, This is my first post here on K20a, and hoping some of you knowledgeable lot can help me out with my predicament. Last week I took my fn2 Type R for a trackday at Silverstone - unfortunately this was cut short after an hours running due to cylinder 1 rod bearing...
1-2 of 2 Results