Search Results for ‘oil pump’

Anyone know the difference between the k20z3 oil chain tensioner vs the k24a's? Here's some part numbers for reference: K20Z3 - 13450-RBC-004 K24Ax - 13450-RAA-A02 I realize they're different part numbers, I'm pretty much asking because of the price difference and if there's a...

Goood Evening K20a.org Just got my K24a8 block back from the machine shop and started to assemble. During assembly I ran into a little problem I did'nt expect, the K20a2oil pump is not a direct fit. There is a raised section on the bottom of the girdle that prevents the pump from sittting...

I'm planning to do a K swap in my crx using a K24A2 tsx head on a K24Z3 accord block. I'm going to use tsx pistons and rod in the K24Z3 block. Plus, a K20A2 oil pump, chains, baffle plate, and chain guides. Looking through some forums, some say there is a hole that need to be blocked off if a...

2006 civic si charge harness: $40 shipped new: 80ish I think k20z3 oil pump: $90 shipped new: 300ish I think The pump has cosmetic damage but still holds oil pressure and is FULLY FUNCTIONALl, I would recommend using it for rebuilding a z3 pump being that the housing is damaged but it would...

Hello, Up for sale are a set of pistons and con-rods with bolts that I pulled from a CRV Engine with about 110,000 miles on it. The pistons are in very good condition. There is no discoloration from heat damage and they are coming from an engine that seems to have been well maintained. The...

I got a Gsr nucles with 36 mm hubs and extended stud $450 shipped no rotor or brake pads the are 4x100 usdm exedy stage one clucth disc and presure plate used for 700 to a 1000 miles. $125 shipped k20 oil pump $60 shipped used but good condition

anyone with experience in the swapping of pumps?? seems like it might be the best of both worlds balance shafts for smoother idle and enough umph for top end oiling.

I have a parted k20z1 with some parts left over for sale 1.) Z1 Oil pump (SOLD) 2.) Z1 Oil Pan (SOLD) 3.) Z1 ECU 4.) Z1 Knock Sensor (SOLD) 5.) Z1 Oil Pressure Sensor 6.) Timing Chain Cover 7.) Flywheel Plate 8.) Z1 Primary O2 Sensor (SOLD) 9.) All four ignition coils 10.) Power steering pump...

Here is a pic comparing the A1/3 oil pump and the A2 pump. Notice that they use the same exact inner and outer rotors with the same exact oil pressure relief piston and spring. There is more of a reservoir for the oil after it has left the rotor of the A1/3 pump as it has to travel back across...