Honda / Acura K20a K24a Engine Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 64 Results
  1. All other models (mr2, mini etc)
    I swapped a 2000 Subaru Impreza 2.5 RS Coupe with a K series. It's a K24A2 with an ebay GT35 turbo. Running Haltech ECU. No clue on power, running ~10psi right now but gonna crank it up soon I made a video about it:
  2. General K-series related talk
    Help, I have a 1997 civic k24a2 swapped and when I go into vtec in any gear at 4,000 rpm’s it makes this rattle/tapping noise, and it’s only at 4,000 rpm it does it. It sounds like it’s in the head?, I replaced the vtec solenoid thinking it might be that but it wasn’t, it only does it under load...
  3. All Motor K series Technical Discussion
    this car only races, doesn’t get driven on the streets K24a2 tsx block, k20a2 head, DC 3.2 cams w/Supertech head package Oil: Valvoline VR1 20w50 Fuel: X85 It is a fresh build and on a cold start it’ll idle around 30-40 psi (have AEM Xseries gauge) but after running it, and getting it warmed...
  4. General K-series related talk
    Hey everyone, long time reader, first time poster. Here's my current race build: (Note: cannot run boost or turbo) 04 RSX Type S K20a2 Type S head K24a2 TSX Block KPRO v4 Type S Oil Pump RBC Intake Manifold Drag Cartel 3.2 cams w/ head package Stock TB 08 Civic SI 6 speed LSD Tranny (4.76 FD)...
  5. General K-series related talk
    I’m looking for some parts and dont know where I could order everything all at one time Im looking for Rsx type-s Oil pump All parts that will be needed for this conversation All Gaskets for k24a2 Looking for gasket kits that come with everything I will need from the top of the head down to...
  6. General K-series related talk
    Hey guys I just finished putting the type s oil pump and 50 degree cam gear to my 2006 k24a2 I want to go boosted but I don’t know what turbo to buy what it could be the best turbo for a 2006 k24a2 I’m shootings for 400-500 hp and I also want a quick spool and I want my car to be good in the...
  7. Introduction Forum
    K24a engine is Found in: Honda Odyssey absolute Honda Accord type s K24a is basically the same as the 04/05 usdm k24a2, except the k24a makes more torque. K24a specs: (early years 03-08) RBB1/2 197 HP @6800rpm 171 TQ @4500rpm Rev limiter: 7200 K24a2 usdm specs: 04/05 197hp @6800rpm 166Tq...
  8. Engine Building
    Hey Guys, I've been lurking around for awhile planning my build and trying to learn as much as I can about the K-series engines. I've got everything planned out for the most part, but wanted to see if anyone can give me some guidance. First off, my goal is to be around 270HP all motor with a jdm...
  9. General K-series related talk
    Hello, I have a white 2002 rsx base. Cutting to the chase I am looking at either a k20z1,k20a2, and a k24a2 for my build. Not sure what one is better for track use holding around 600hp with a 6spd transmission. But I need to know which of the three have stronger internals, as well as pros and...
  10. 2001+ Civic EP3 / RSX DC5 / EM2
    Please move post if I posted it in the wrong area I’m new here. What’s up I need help I k24a2 swapped my 07 fa5 am running into issues. I have engine code p1009. I cleaned the vtc solenoid and got a new vtc filter. Tested vtc with 12v and it’s not stuck. I swapped the 50 degree vtc from my k20...
  11. Forced Induction and Nitrous K series discussion
    I’m thinking about picking up a RSX Type S here soon and was wondering what comfortable power I could be at on a bone stock K24A2 block, head & transmission if I was to put boost to it. I did some research but I never got a straight up answer yet. I’m wondering if I could push 400-450whp out of...
  12. General K-series related talk
    This is my attempt 2 do a super cheap k swap into a Ek. Here is the what I have so far please feel free to correct me. I need all the help I can get. #kswaptheworld Motor: K24A2-300-junkyard Tranny: rsx type S 6 spd- 300-junkyard Mounts: 300 Crv side bracket: 50 Subframe: Eg-50-junkyard Axles...
  13. Forced Induction and Nitrous K series discussion
    Hello Which parts i need to my k24a2 give 500whp for the street drive with fuel gas Now my engine is 100% stock... Tnx everybody
  14. 1992+ Civic EG / DC2 / EK K-Series Swap
    Hello All. I'm towards the end of my project and I now need to look into getting an exhaust. I have Megan Racing k swap header. For those who has or had a k24a2 EK Hatch...Suggestions on a non stressful but not too expensive route? Definitely something that's not too loud or janky. I saw...
  15. ECU and Tuning
    Hey lady’s and gents, My set up is a: K24a2 Type s pump Rbc manifold Intake & exhaust Ep3 trans Ktuned rail 650 grams injector K20 crank sensor Kpro v4
  16. Wiring and Electronics
    HELLO FORUM MY NAME IS CHRIS IM NEW TO THE K SERIES SCENE CURRENTLY DOING A K24A2 BLOCK WITH A K20Z3 HEAD I WAS TOLD THAT THE EP3 HARNESS WOULD BE ABLE TO RUN MY SWAP IVE ALSO BEEN TOLD THAT THE EP3 AND RSX BASE SHARE ALOT OF SIMILARITIES SUCH AS AXLES SO MY QUESTION IS COULD RUN MY SWAP WITH A...
  17. 1992+ Civic EG / DC2 / EK K-Series Swap
    I attempted to search for an answer in the forums but did not find an answer so im hoping one of you can help me out. It would be much appreciated. I bought k20a3 with 5 speed trans at first to swap into my 93 del sol i accumulated parts that was shown required in a end all thread for kswap...
  18. K-series powered Kit cars
    New to the Honda world but have a good friend in the scene in my town and putting a K24a2 in my ‘81 280zx I have in my garage right now. Few questions for people that have done builds on these motors. I want to turbo but don’t want to spend upwards of thousand rebuilding the bottom end to handle...
  19. All Motor K series Technical Discussion
    So I'm a noob when it comes to k series motors. I'll be picking up a K24A8 on Saturday to rebuild. From what I understand, the A8 only has vtec on the intake cam and the A2 has vtec on the intake and exhaust cam. Could you use an A2 exhaust cam and rocker arms on the A8 with new valves and...
  20. All Motor K series Technical Discussion
    Critique my build...A k24/k20 RWD ITB NA 91oc 250whp hopeful Hi guys, can you please critique my build? I have tried to do my due diligence, but I'm still a full blow noob and know just enough to spend a lot of money on the wrong parts. I'd love your help or suggestions on my build. I have...
1-20 of 64 Results
Top