Honda / Acura K20a K24a Engine Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Forced Induction and Nitrous K series discussion
    Hi guys im new here so i been searching online and look for advice im based in the uk try to swap a k20 in a ep2 d16 there alot of cheap k20a3 is it worth getting one im aiming for around 500hp i know that the internals are weak but im planning to upgrade that my plan is to open the hole motor...
  2. Engine Building
    So I bought a 2006 TSX and the guy said he swapped the engine and did the K20 block with the K24 head. But he’s got no paper work and I’m trying to visually confirm that’s what happened. Is there any way for me to look down into the bay and see? I know they look super similar and I’m not the...
  3. All Motor K series Technical Discussion
    Do anyone know if I can put a k20a2 head or k20a head on my k24a4 ? If so after that can I upgrade the cams to drag cartel 3.2 ?
  4. Forced Induction and Nitrous K series discussion
    K20a2 bored to 87mm. Do I need block guard? I am installing wiseco 87mm 10.2.1 compression and engine it’s fully built. Looking to handle 500-650 whp * also what turbo and fuel system do you guys recommend for my setup? thanks in advance!
  5. Motors / Swaps for sale
    basically I need a crankshaft. I spun a rod bearing and after I measured out the crank journals they are to far out of spec to think about sending it to a shop, so I need one. Also I can do a short block (crank, rods, pistons, bearings, etc) please text me at 704,651,506seven (I DONT GET ON...
1-5 of 5 Results
Top