Honda / Acura K20a K24a Engine Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. NEW - Welding and Fabrication Forum
    Hey everyone, I just wanted to document this build for anyone in the same boat as me, or if you're just interested in DIY. Over the last few weeks I've been working on a RWD intake for a K swap I'm doing. Since the cast one from Kpower didn't really appeal to me , and the Skunk2 two piece ones...
  2. Wiring and Electronics
    Guys, Here's an update to the old gauge I have. I want something simple and affordable that works. Check out the gauge and give me some feedback. Features: Boost controller OLED 1.3" white microcontroller based Mac Solenoid Air Fuel Ratio 0-5 volts 7.35-22afr input for LC-1 4bar map...
  3. All Motor K series Technical Discussion
    The setup k24a block 89mm sleeves INLINEPRO IPS 8620 K2 mark2 cams IPS JE 12.5:1 compression pistons IB SPEC RODS k24a I beam SSR HEADER FOR K20a2 motors 4-2-1 STOCK RBC with karcepts ADAPTER STOCK THROTTLE BODY Karcepts Intake STOCK 99mm crank STOCK 2006 Civic Si head SUPERTECH spings...
  4. General K-series related talk
    ★☆★☆★☆★☆★☆★☆★☆★☆★☆★ ☆SEE THE ENTIRE THREAD HERE☆ ★☆★☆★☆★☆★☆★☆★☆★☆★☆★ Comments, Suggestions, and Submissions are Welcomed If you do not see the information you are looking for here, check the Stickied threads in the Subforums. If you do not see what you are looking for, you can search the...
1-4 of 4 Results
Top