Honda / Acura K20a K24a Engine Forum banner

Search results

1-8 of 8 Results
Advanced Search
  1. K24a2 - Where is the torque?

    All Motor K series Technical Discussion
    check theres no restriction in the exhaust system, or the system is to big ie 3" Kaspa
  2. Official: Dyno Chart Comparison & Calibration Registry

    All Motor K series Technical Discussion
    Engine K24,Z3 engine stock, inlet manifold Skunk 75mm manual throttle body, Nissan SRdet turbo 10lb boost, fuel E85 Haltech Elite 1500 ecu.7000 max rpm 285 RWHP 432ft lb torque dyno sheet attached Blue line is the Orig K20 Z4 Type R engine for comparison
  3. K24 running rough

    General K-series related talk
    Low oil press was caused by excessive bearing wear, gave it a complete over haul, I think the running rough is because the engine is solid mounted. all jokes aside, i just couldn't believe how smooth these Honda engines are, there is now way you would assume this thing has the power it has as it...
  4. K24 running rough

    General K-series related talk
    Guys ive got a bit of a problem, i rebuilt my K24 Z3 engine after a low oil pressure problem fitted it back into the rocket and fired it up and it started fine but everytime i put a stand 50cent coin on the rocker cover it sits there for a while but soon as i give it a rev it falls over...
  5. K24Z3 turbo powered Lotus 23

    K-series powered Kit cars
    Hi guys following on from the introduction thread i thought id post my rocket on here. My build is a replica Lotus 23B i built with a K24Z3 turbo in the rear coupled up to a Subaru CR 5 speed transaxle running upside down. the engine is basically stock the only additions being an 80mm manual...
  6. New guy from down under

    Introduction Forum
    hi mate yeah i have a mate Frances in Austria that also has a k20 in his but he has mounted his east west with the orig trans, where as mine is north south coupled to a Subaru 5 speed trans axle. i built it originally with a K20 type R engine but the timing chain let go and stuffed it after 2...
  7. New guy from down under

    Introduction Forum
    Hi guys Kaspa here from down under in sunny Queensland Australia, i have a little Lotus 23 race car i built with a K24 Z3 turbo in the rear, fun little jigger, it only weighs 540kg and has a modest 295 RWHP and 450ft lbs of torque on just 10lbs of boost at 7000rpm, Being very new to the Honda...
  8. Introduction thread for people that cannot wait 24 hours to make their own thread

    Introduction Forum
    Hi guys Kaspa here from down under in sunny Queensland Australia, i have a little Lotus 23 race car i built with a K24 Z3 turbo in the rear, fun little jigger, it only weighs 540kg and has a modest 295 RWHP and 450ft lbs of torque on just 10lbs of boost at 7000rpm, Being very new to the Honda...
1-8 of 8 Results
Top