Honda / Acura K20a K24a Engine Forum banner

Totaled my car, part up forsale

13K views 59 replies 23 participants last post by  tunerboy 
#1 ·
Totaled my car, part up forsale (kpro, ITR, various parts)

SOLD:
MOTOR,
Trans,
Wire harness
starter
EKS1 mounts
Oil Pump
Oil Pan
Wiesco pistons/blueprint rods
K-PRO



Rather than put my name on every pick this is me and this is my car:

You can paypal / Email me: glen.r.newell@gmail.com

So i totaled my car and have been tearing it a part getting all the valuable goodies off to sale at the cheepest prices, so that i can pay off all my debt and fix my hatch. Im getting out of the honda game for good so yall can make me an offer and if its decent enough ill take it. So here it goes.


k20a2 Alt + Charge harness
100 Shipped


Intermediate shaft
110 Shipped


Type R TB w/ all sensors
165 shipped

RSX-S front motor mount w/ energy suspesnsion inserts 70 shipped


Civic Front and RSX-S rear sway bars 70 each or 130 shipped combo


No name muffler 50 shipped


JRRH RSX Type S + Test pipe w/ exhaust cut out& 02 sensors 400 Shipped


RC 650cc injectors 200 shipped


Si Radiator w/mugen fan temp switch, radiator cap and fans 110 shipped


RSX type-S Head Complete 600 Shipped


Type R Valve Springs 60 Shipped:


Type S Chian + guides 35 Shipped:


Red Sparco Turinos w/civic brackets and slider 400 picked up only


EP3 civic SI blower w/3.8 & 4 blower pulley, k24a4 crank pulley, map sensor adapter, 70mm bored intake runner, stock intake runner, and 2" idle pulley *if i can find the 2.5" ill throw it in too 1300 Shipped
 
See less See more
17
#43 ·
The Japanese PRD and PRC ECU do not support a fuel tank pressure sensor required for some US emissions tests, but will likely pass a tailpipe sniffer test if the catalytic converter is in place.


That is all I saw on the hondata site about the PRC ecu.
Now will this kpro setup work in my EG swapped car?
 
This post has been deleted
You have insufficient privileges to reply here.
Top