Installing RSX Shifter??

[92si]

I understand that you need to run the cable linkage through to the tranny. When you drill the hole for the linkage (i read somewhere) that you need to be very carefull not to hit the main wiring in the frame. Is there a different way to do this? Or any tricks for doing it? I haven't seen this discussed in a while.

[909rex]

ummm.... just look to see where your drilling.. :twisted:

[Colorofmoney]

ummm.... just look to see where your drilling.. :twisted:

909Rex atleast give him a complete anwser.
I understand that you need to run the cable linkage through to the tranny. When you drill the hole for the linkage (i read somewhere) that you need to be very carefull not to hit the main wiring in the frame. Is there a different way to do this? Or any tricks for doing it? I haven't seen this discussed in a while.

You see the middle of the fire wall the low spot? (The 2 long black wires) To be exact you run it to the transmission it does not go through it. There is no main wiring there except for the climate control harness.

http://www.k20a.org/images/K20EGprogress1.jpg

[909rex]

it was good enough.. :D

[92si]

Thanks.

[92si]

Is installing the shifter similar to this?

http://www.hondatuningmagazine.com/tech/0309ht_swap/

[NEIR]

ummm.... just look to see where your drilling.. :twisted:

909Rex atleast give him a complete anwser.
I understand that you need to run the cable linkage through to the tranny. When you drill the hole for the linkage (i read somewhere) that you need to be very carefull not to hit the main wiring in the frame. Is there a different way to do this? Or any tricks for doing it? I haven't seen this discussed in a while.

You see the middle of the fire wall the low spot? (The 2 long black wires) To be exact you run it to the transmission it does not go through it. There is no main wiring there except for the climate control harness.

http://www.k20a.org/images/K20EGprogress1.jpg


I did not understand your post at all......

[supafly]

I cut a hole below the Heater core lines. about 4-5 inches.

Looking inside the car I went flush with tunnel. Worked great.

Cut a hole about 2x3.