- AEM EMS...does it control reverse lockout solenoid?
- K24A2--rsx-s Tranny What Kpro Ecu works the best with this Setup??
- Need help...charging system problem
- all dash lights are on --kpro
- 02 Sensor Problems
- need info on rsx type s smog california
- EP3 cluster pinouts
- Want to switch to AEM EMS from KPro, but car will not start
- k20a2 swap with a k-pro'd k20a3 ecu??
- Kpro with tune, can I hook up laptop and not lose tune.
- A/F Ratio Gauge...
- Where to get wire thats needed for conversion harness???
- No spark!
- Tired of people asking me for the RSX Helms Manual. SO HERE IT IS!
- wow...i dont get it....headlights
- need help for my k20z1 with my kpro
- noob here
- ITR gauge cluster
- VSS wire
- engine temp gauge doesnt work
- K20A2 In 97 EK
- kpro ecu related problems
- prc j01????????????
- K-Pro Calibration
- any info on p1auto
- k20z1
- psp switch output operable on pnf ecu?
- Wiring K24a2 to EK hatch.
- Check Engine Code- P0600
- IACV, can it be disabled?
- Need help wiring cooling fan to K-pro
- srs!!!!! why....???
- 02 EP3 with a P1166 code
- Where can I order the "E Plug"?
- TPS High Voltage.
- Check Engine Light Blinking?
- P0325 code
- EP3 cluster
- Hybrid Wiring Help !!!!
- stock o2 sensor
- lookin for decent tune with RBC
- Gauge cluster pin out
- Power tuning witout a Dyno:DynoRaz Cam Composite Program
- Road Tunning K-pro
- does kpro come with a map for the k24a4?
- 06 si ecu
- I don't know what to do
- Whats the difference between K and B series injectors?
- Rsx Relays?
- lots of knock?!
- Ignition Coil output
- TSX/S Frank Idea for basemap
- need help on kpro
- Lagging b4 VTEC
- Weird ECU Issues!!! I don't get it!?!?!
- help tsx harness
- K20z1 Help Please
- Need help starting
- K20a Charge Harness
- reflash or greddy e-manage
- car wont start- wiring problems
- 06 SI O2 sensor on PRB ECU
- EG c302 pinout
- Oil Pressure Gauge...
- How do I read check engine code ?!??!?
- **K24a2 S/c** Crazy A/f!!
- hybrid o2 wires which goes where?
- rpm doesn't work
- CEL Help!!!
- Throttle Position Sensor: Base vs. Type S
- Where the crap can I find this connector...
- Alternator problem!!!Battery not charging!!!
- NO SPARK whats wrong?
- i need prime tuning
- CEL issues
- Sensors
- K20Z1 wiring into EM2
- K-Pro?
- Harness
- Building an engine harness, need parts but where to get? Pins, plugs, etc...
- oem primary o2 reading 25??? wtf
- Does a grounding kit help the performance of the engine?
- k20a harness on k24a1, does it fit?
- tuning fuel & spark for a specific cam angle
- Motor Lags from 4700-5000rpm *datalog inside*
- K24a2 ecu and wiring
- KPRO - initial sensor readings, Need Help
- lambda sensors
- car has problems starting and loses power
- A/F Ratio on K24 Frank
- K20a ITR
- Good tuner in Saint Louis area?
- Convert subharness?
- Cel 39
- solving backwards wiring
- kpro shift light
- Is K-pro the only way? What are the other options?
- hondat v.s. aem ems
- the cooolest gage
- 05 rsx-s needs diagram for vafc2 hard wire
- type s harness in tsx HELP!!
- Primary 02 pinout
- k24 k20 running rich as hell
- immobilizer removal or just get hondata?
- IACV Malfunction
- k24/k20 Hybrid base map
- I have a question about kpro.
- need help have cels
- wideband identification marks
- AEM EMS problem
- will a k24 alternator fit a k20
- trouble shooting, car wont start
- Sensor identification
- need help oxygen sensor
- k-pro wtf
- crash course in kpro
- K-pro question
- Quick Wiring Question
- God damn kpro!!!!!!!
- kpro + hydrogen enriched fuel?
- ECU "A" Connector Help
- e-plug and C101 plug
- Which would you choose????
- Seeking tuning advice for my Rcrew cam basemap
- Could K pro manager calculate MPG?
- battery light always on?
- kpro gear comp.?
- Cel Light!
- KDisplay - See your fuel consumption in real-time
- your o2 plug from your harness question.
- EK pinouts required for C101 and C131
- Fuel pump relay wiring help
- Whats your CLV?
- need help with prc ecu plz help
- sputter
- k-pro calibration question
- k20/24 cal. help
- Euro type r ecu pin outs same/similar as us rsx s version?
- K20A2 wiring harness same as base K20A3?
- s2k cluster help!!!!!
- Car not priming
- Ignition Timing tip. (All tuners)
- wiring harness
- type-R ecu with k20z1? will that work?
- Will A K24A4 Starter Work On A 6 Speed RSX Type S Trans?
- HELP:engine not going pass 2k rpms!!!!!!
- AEM UEGO to replace stock A/F ratio sensor?
- Hondata K-PRO / AEM PEMS
- k-series eg swap and ecu..
- How to tell what type an ecu is
- K count of 16
- NS6 primary O2 sensor?
- RBC ecu?
- JDM ECU Pinouts
- k20z1 motor with 06 civic ecu
- K20A engine harnass help
- HELP! Firewall Main Harness
- URG: KPRO SENSORS HELP not reading
- datalogging cam angles
- EGT & fuel trim % - anyone have results from 4 egts
- ecu info
- how to rest ecu?
- K24 ecu question
- Will KPRO work for me in this case?
- maybe obvious question about VTC
- Stock K24 CAL question
- blowin alternator fuse
- Differences in K harnesses?
- What wires are these??
- Idle and Temp gauge problems
- Upgrade from K100 to K-Pro
- How to get rid of immobilizer?
- What are the real differences produced between the K-Pro and the Greddy Ultimate?
- where to get Kpro?
- Wire tuck in EG: Can it be done without extending wires?
- Wiring up a K24?
- Can I use these ECUs?
- Where to buy harness connectors?
- FYI: Engine Management Calibrations
- help starting up my car
- K-Pro in Element now possible....
- changing maps too often
- Anyone using AEM ecu????
- problem at 4000rpm!!!!
- running lean
- Car won't start...Corrupted .cal? HELP!
- jdm DC5R gauge cluster in EG-wire up?
- wiring a harness with one relay
- K-Pro for a K24a8 ????
- Comptech Reflash
- rev limiter at 5500 overnight?
- KPro Tunning in FL
- Help with wire into ecu connector
- Can I mod an EG harness to work in an EF?
- Building 06 Civic Si for road race, Check engine output signal
- Wireharness whoa's...
- Help Diagnose Engine Cutout
- ecu, wire harness,vss ???????
- do i need kpro
- Does DC5 jdm ECU have immobilizer?
- rcrew or hybrid?????
- Maintence Required light on: CODE P1298
- Gas light never on??
- Can a TSX basemap be used for K24A4/K20?
- Vtec Help!!!
- K20A2 EP - crank but no start - cam angle issue?
- What exactly do i need to switch from AEM 1070 to Kpro
- K - pro problem,
- ecu problems
- Hondata hates Mac...
- Crank Position Sensor K24a vs K20a
- parts wanted
- RHD EK hatch engine wire harness 96-98 VTI / SIR / CTR
- DC5 Type R ECU Kpro'd?
- Charge Harness help...
- Best place to mout IAT sensor??
- Help Blowing Ecu Fuse Again And Again
- ep3k20a3 to k24a4
- nitrous wiring to kpro help
- 04 rsx type-s K-pro Help
- Anyone have an RSX Helms? Question about it
- Fan plug??
- Hondata 9, 14, 20 pinout to main relay?
- o2 sensor
- 92-95: Best wire harness out there? pnp wanted!
- AEM 1070 users I need help
- Battery/Charge light not coming on...suggestions?
- NEED HELP ASAP...kpro ECT reading
- Dyno Results (Nothing big)
- MAP sensor problems?
- USDM PRB ECU working with JDM ITR harness in DA/DC swap...kinda wierd
- KAutoFuel - Tool for tuning partial throttle
- normal MAP seonsor values-KPRO
- Problem with starting , injectors not working
- Turned off speedo
- EK wiring question.. JDM harness, Type S ecu, R-Crew pnp harness?
- has anyone tried aftermarket wideband for Kpro?
- Adding fuel with no resuts???
- Normal AFR sensor values
- K20 A SpecR which ecu?
- MSD Dashhawk?
- 06 Harness w/04 Tranny speedo Help?
- immobilizer
- Opinions/Experience: Which wiring harness for EK
- PRC Ecu?
- SFC vtec controlers
- K20z1 calibration
- Interesting ECM Question HELP
- Wtf P0131 ???????
- Brand new hondata k-pro problems - what's wrong?