- k20a3 block ????
- k24/k20 Questions
- vtec oil pressure sensor question
- CEL that has been haunting my boosted setup
- Accord 2.4 tuning
- Compression Ratio Limits
- stroker kits???
- Motor runs fine at times but then suddendly dies?
- how reliable is a k20/k24
- Hybrid racing A/C kit
- Where is the center of a CRV drivetrain?
- good or bad price for k20a2?
- Here's what a K24 drivetrain weighs
- wich bracket do i need to use kswap
- idle is ok when car is parked but when i come to a stop it dies??
- In Need Of A Good Mechanic In Central New Jersey????
- Brass Fitting on RBC Intake Manifold (Possible to pull and tap for 1/8npt)
- Oil Catch Can:
- shifter cable/box combo for 5 speed tanny
- unwelded rwd k series header
- Ball joints
- 4th and 5th gear wont pass 5k rpm, please help
- noob question - What oil filter for this setup not sure what year etc
- stroker kit to k24a3
- Hello everybody, noob needs some info/opinions on purchasing k20a2
- C101 Pinout Needed
- HELP PLEASE !! 02 RSX TypeS(car) with 02 K20A3 swap possible ??
- swap k20a3 with k20a2 or k24?
- k20 eg, car won't start
- water pump ?
- highest compression ratio in stock k20
- help finding picture
- An industry Rant...Help me understand...
- vendors that sales stage 4 comp. clutch kit?
- 08 civic final drive compartible with 03 rsx tranny?
- Unplugged Oil Pressure Sender
- Is It True????
- FPR open vac.?
- Shipping a k24......weight and methods
- Hot Rod Rsx
- Timing chain jumped a tooth or more @ crank during cam install
- top coolant hose with RBC
- Bare K20Z1 head part number?
- Need a shop/garage in Germany.
- k20a3 valve adjustment ?
- rsx-s injectors
- Where to get header springs?
- hondata issue
- How I installed my timing chain in time after cam install -- helpful information.
- k24a2 Throttle cable Bracket
- Hondata Seminar Video
- k24/k20--sensors and mounts question
- Fuel leak: Golden Eagle rail / Earl's swivel seal AN fittings
- Help Please k24a4 gasket leaking internally ?
- k20a3 w/ 6speed tranny Questions?
- im going to do a k20a swap into a 94 civic
- car dying, please help
- fuel pressure drop
- which Oxygen sensor/o2 sensor to use?
- Vibrating noise at 5000rpm decelerating???
- OK to run K swap on kpro basemap w/o primary oxygen sensor?
- k20 belt help!!!!!
- Q--pulley system
- Ek k24 overheating in less than 2 min of starting car help please from k20 experts !
- k20a2 problems, please help me gurus!
- Summer Vacation Troubles
- Question that needs an answer quickly. PLEASE LOOK!
- quick RBC IM swap to k24a2 head question
- what kind of cams shafts
- kpro in 07 si
- Gauge mounting!
- help, throttle cable issue
- Custom A/C lines, what size tubing?
- fuel rail + injector question
- k24 block in rsx-s ??
- Happy Upcoming Birthday K20a.org is about to be 5 years old
- which o2 to use for k20a?
- crx k20
- Wierd problem with k20
- car wount pass 2000rpm
- k24a8 on eg with 05 rsx harness wont start
- H1 car in honda tuning made 29x whp!!!
- WHP vs HP What is the differece
- knock sensor pic
- Simple question, just need an answer...
- Cracked plate on hassport mount on eg??
- A Better Coilpack?
- help first k20a2 and im all alone
- Cam Sensors Interchangeable?
- need help.. spark plugs keep flooding.
- K20a2 head vs. K20z3
- Help which primary o2 to use?
- What cv boot will fit a hasport driveshaft??
- Hot air blowing constantly?
- So i have a dilemna to build or buy k20 help
- Took back my video
- Dakota digital converter
- i have a k20a question
- toruku cam install ?'s
- Clutch line problem, help please
- I hate when this happens.
- welding
- Label these pictures inside
- Speed sensor 06 tranny
- Charge harness help
- K20a or K24 into my ek hatch??
- Hondata IMG & cold weather?
- k24 block + k20a head or k20a
- Help with K20 Mount location in DA.
- help not starting?
- Can i ask about a non k. EG Problem I have.ez fix
- witch parts is interchangeable between K24a2 head and K20a2 head?
- Hondata Heatshield
- I need help with getting the crank pulley bolt off
- Symptoms of loose valves?
- CLutch Alignment Tool
- K swap eg to Dc,will all parts work?
- K24a2 with Type S oil pan? Benefits? Pros and Cons?
- Coolant Woes
- k24 pistons
- need engine bay help!
- Belt Size??
- Need some help..
- Sizing up slicks for k24 setup
- slipping clutch
- header
- k24 sensors with a2 harness?
- surging problems 2
- is this a good price??
- I need a 3" CAT converter to pass emmisions
- EP3 idler pulley...SIMPLE QUESTION
- k24a4 need help with finding correct knox sensor asap !
- k24 tsx into 94-97 accord
- Need Help Please!!!
- fuel rail to fuel line fitting size and part number?
- Is a purge control solenoid needed?
- shifter box questions...best.one?
- need help asap with pnp harness
- Are all L.M.A the same?
- k24z bottom end
- fuel set up
- DC IAT vs RSX IAT
- One issues, Leads to Many
- PPL from CALI, i need help, (if u've gotten a fixaticket)
- how much a oil for a k24?
- Port on TSX head?
- Sensor question
- plz help >> speed limit in 219km/h
- 2 ??? Intake And Headers
- k20 head code
- can someone tell me if the tsx head is good 4 turbo?
- socket size for the oil cooler?
- oxygen sensor
- Fuel setup problem
- difference in k24 blocks? more than comp
- I Have A Couple Questions
- transmission case stuck on bellhousing
- Help me figure out what year is my k20a
- Carbing Radiator Reservoir - setup questions
- fuel pump help
- Where to buy diff bearings for cheap?
- Best place to get TSX 6spds
- hey guys! Im thinking of coming back! Where is the cheapest ITR swap??
- flashing a key
- Whats the diffrence between a k20a2 and a k20 z3??
- possible to have a/c with a 92-00 civic kswaped?
- Lugs
- Polishing Mounts Help!
- oil pan options
- TSX K24a2 Water Coolant Bypass & FPR?
- -6 fuel lines
- no spark?
- difference 6-spd vs 5-spd clutch?
- picked up a free head.... ppl?
- Disappointed on my 1/4 mile run tonight!!!!
- Which clutch to run
- Using stock rail
- what intake to use ?
- M.factory Helical Lsd?
- MUGEN and SPOON THERMOSTAT
- Hybrid K20 Civic Type-R?
- AiM Sports - MXL clusters
- which EMS?
- Difference between Axels?
- K20a2 or k20\k24
- insurance question on a k car
- honda making a new engine? Or just building on k series?
- dying interior HELP!!!!
- help with advid racing mounts :(
- No VTEC, NO CEL
- Anyone run a different oil pan , dipstick question
- Putting Vtecspeed1320 On Blast, Where's My Stuff Vol. No More Excuses
- K20A3 longblock & Ecu, A2 tranny & wire harness..advice plz?
- base drive-shaft vs type-s drive-shaft?
- Whats the difference between z1 & ITR cams??
- Dc5 JDM Spec 0-60 mph times
- o2
- Going k24a3 swap for my ek hatch
- Element, swap and hondata questions
- plenums?
- Which head is it?????
- need a part for a head
- brake job blues
- ASP's new toy
- jdm prc ecu immobilizer ?
- what weight of oil i should run??
- vtc?
- Cam Cap Assembly
- Could anyone tell me what upper rad hose this is
- Help k24a2 questions
- 2009 Honda Insight Concept Hybrid
- kswap Qs?
- k24/k20 build and tranny
- Hybrid Racing and Hurricane Gustav Relief
- Hybrid Racing mounts...
- have a k24/k20 frank buil could use help
- k20/k24 rbc eg DOESN'T FIT!!!
- Radiator Fan for Fluidyne
- A/C and P/S Removal for K20a Swap
- how identify type r cams vs. type s cams
- Help ps in ek question???
- K24 w/ PS but no A/C
- Power Steering Noise
- k24a4 with k20 no ptv
- searching for right spark plug - my k series has silvia plugs???
- Help post pics on your ps setup on EKs
- fujita cai.
- How to jump starter for compression test??
- Been trying for over a year to break 14s in the 1/4
- Acura dealership wants VIN# to warranty a faulty 02 sensor
- multi-plex ?s
- is this normal wear?
- How much is a k24a2 longblock worth..?
- Need help, K20 won't start after engine warmed up, fresh swap. please help
- car will not start anymore....
- car wont start and have 3 cell
- fitment???--dc/rbc/manifold cover?
- need help - 3" exhaust for EK hatch. PIC request.
- new to honda performance swaps
- oem piston ??????
- Is a set of Ips K2 and Eibach springs and retainers worth trading for a K20z1?
- Trust/Greddy declares bankruptcy
- quick question
- how much does engine weigh?
- Muffler to stop drone
- Bad influence
- K20 dimensions?
- Stay B series or Go K series?! Need Help...
- cam shopping
- question about upgrading kpro